Ideal for rack toms, floor tom, congas and horns. Slight mid-bass boost.
The D2 is used for stage, studio and broadcast
applications. It is designed with a hypercardioid pickup pattern for
isolation and feedback control and is equipped with a VLM™ diaphragm for
natural, accurate sound reproduction.
The D2 is an
excellent choice for miking instruments with a percussive nature such as
rack toms, congas, saxophones, guitar cabinets and brass. Transformer
less design, low impedance and balanced output insure that the D2 will
perform interference-free.
The D2 is lightweight, compact and easy to position. With a wide
frequency response of 44 Hz - 18 kHz and the ability to handle SPLs in
excess of 144 dB, the D2 is an excellent choice for miking instruments
with a percussive nature such as rack toms, congas, saxophones, guitar
cabinets and brass.
The D2 is manufactured with a precision machined
aluminum body, black anodized finish, laser etched model and serial
number, steel mesh grill, Switchcraft XLR connector and is supplied with
a tension-fit heavy-duty nylon microphone clip. Transformerless design,
low impedance and balanced output allow for interference-free
performance; even with long cable runs.
Transducer Type: Dynamic
Frequency Response: 44 Hz - 18 kHz Polar Pattern: HypercardioidOutput
Impedance: 250 ohms Sensitivity: 1.2 mV/Pascal @ 1k Off Axis Rejection:
> 30 dB Maximum SPL: >144 dB
- Transducer Dynamic VLM Type B (Transformerless)
- Polar Pattern Hypercardioid
- Frequency Response 44Hz to 18kHz
- Dynamic Range (Typical) Not Specified by Manufacturer
- Signal-to-Noise Ratio Not Specified by Manufacturer
- Maximum Input Sound Level 144dB
- Power Requirements Dynamic Transducer - no external power required
- Output Impedance 250 Ohms
- Output Connectors 3-pin XLR male
- Pad No
- Low Frequency Roll-Off Natural roll-off at 44Hz not switchable
- Dimensions Not Specified by Manufacturer
- Weight 4.5 oz (128g)
- Download spec sheet
Audix Limited Warranty Audix guarantees our products to be free of manufacturing defects as follows: 5 years for dynamic microphones. 3 years for condensers and wireless products.
Products found to be malfunctioning due to a manufacturing defect will be repaired or replaced at no charge to the customer. All other repairs will result in a nominal service charge
|
